JHM biomass pellet die ,vietnam feed pellet,

JHM biomass pellet die ,vietnam feed pellet,

JHM biomass pellet die ,vietnam feed pellet,

JIUHE MACHINERY hereby sincerely invites you and your company representatives to visit our booth at VICTAM LATAM 2025, which locates at EXPO CENTER NORTE, WHITE PAVILION, SÃO PAULO, BRAZIL, from 16-18 September, 2025.

Install the blocked ring die on the machine, mix 100-200kg pellet (diameter of the pellet should be same as ring die hole diameter. For example, 2mm die uses 2mm pellet) with 3-5% water and 4%-5% oil evenly. Flush the hole channel for 10-20 minutes. After all blocked channels are cleaned, we can start normal production.

Take the pellets just produced (the crushed size of the raw material, and the hole diameter of the hammer mill screen should not be larger than the hole channel diameter of the pellet dies to be washed). The amount of pellet depends on the size of the pellet die, such as, inner diameter is no bigger than 558mm, which needs around 50kg~100kg of pellets. The moisture content is best when the pellet

​When installing roller shell, you should check whether the work surface of roller and ring die is in suitable position. The machine can’t work under the condition that roller shell touches the ring die feed channel, or it will casue damage of the ring die and roller shell.